Galveston PE-33 - modifications

The New Gear: Maintenance, Repair, and Modification Forum.
----Hosted by Al Benoit

Re: Galveston PE-33 - modifications

Postby Alain Benoit » Fri Feb 08, 2013 3:01 pm

Christian LeBlanc wrote:I have no idea how I stayed calm and didn't freak out, especially since there was really nowhere else to put the pickup. Anyway, if anyone's reading this thread in the future: don't use the cheap drill bits that came with your all-in-one drill bit kit, or if you do, keep a very steady hand when drilling in and out. Drill a tiny bit at a time, pull out, go back in a bit further, repeat. And don't just do this on your lap; set this up on a proper table or something.


That's how you broke your bit, not because it was cheap.
Cheap bits are actually softer and although they don't cut as well they are less brittle.
Alloys as with most materials tend to generally trade of hardness (carbon content) for malleability.

A.
www.fluidaudiogroup.com

"No one has time to do it right, but we all seem to have time to do it twice."
User avatar
Alain Benoit
Self Biased Resistor
 
Posts: 1321
Joined: Mon Jul 03, 2006 11:21 am
Location: Canada

Re: Galveston PE-33 - modifications

Postby Christian LeBlanc » Fri Feb 08, 2013 3:29 pm

Thank you for pointing that out; I honestly had no idea.

I'm sorry, drill bit. I mishandled you and then insulted you. I've been there before, and it's no fun; that was very uncool of me.

I feel a song coming on in this...
User avatar
Christian LeBlanc
Silver Member
 
Posts: 486
Joined: Sun Nov 01, 2009 11:05 am

Previous

Return to Fluid Wireworks

Who is online

Users browsing this forum: No registered users and 1 guest

cron