Posted: Fri Jan 05, 2007 8:24 pm
In all likelyhood, I will end up destroying the nut when I remove it to do the fret work. Sure, I could leave it alone, but:
a) it's easier with it out of the way
b) I'd rather replace it with a custom made nut anyway
This is a bit more advanced as it requires some dedicated tools, so...
Tools for making a new nut:
1) A new nut blank - I am using one from Graphtech
2) New string trees - Sure, nothing to do with the nut "per se", but if I'm going to use Graphtech nuts, I may as well use Graphtech string trees.
3) Dial caliper (not shown) - To lay out the string spacing. Don't rely on copying the factory nut.
4) Nut Files - Guaged to match the strings. Nothing worse than a loose slut...er....slot.
5) Miscellaneous files and sandpaper (not shown) - For shaping the new nut.
6) Rum & Coke - Highly recommended.
a) it's easier with it out of the way
b) I'd rather replace it with a custom made nut anyway
This is a bit more advanced as it requires some dedicated tools, so...
Tools for making a new nut:
1) A new nut blank - I am using one from Graphtech
2) New string trees - Sure, nothing to do with the nut "per se", but if I'm going to use Graphtech nuts, I may as well use Graphtech string trees.
3) Dial caliper (not shown) - To lay out the string spacing. Don't rely on copying the factory nut.
4) Nut Files - Guaged to match the strings. Nothing worse than a loose slut...er....slot.
5) Miscellaneous files and sandpaper (not shown) - For shaping the new nut.
6) Rum & Coke - Highly recommended.